Ελλάδα | Eλληνικά
Επιλέξτε τη χώρα σας και τη γλώσσα σας
International
Local websites

BERU Συσκευή δοκιμής μπουζί για χαλύβδινα και κεραμικά μπουζί πυράκτωσης

Με τη σχεδιασμένη από την BERU συσκευή δοκιμής (αρ. παραγγελίας BERU 0 800 115 010) μπορούν να ελεγχθούν γρήγορα, οικονομικά και με ασφάλεια σε οχήματα με τάση ηλεκτρικού κυκλώματος 12 V όλα τα κοινά μπουζί πυράκτωσης (συμπεριλαμβανομένων των κεραμικών μπουζί) – μεμονωμένα, με αυτόματη αναγνώριση τάσης, χωρίς να αφαιρεθούν και χωρίς εκκίνηση του κινητήρα.

Benefits

  • Reliable, fast and economical testing because there is no need to dismantle the glow plugs, or start the engine
  • No need to pre-set the glow plug type (steel or ceramic)
  • Detects automatically the glow plug voltage (from 3.3 to 15 volt)
  • Tests in real-life conditions
  • Easy to use
  • Can test each glow plug separately
  • Analogue display of heating and current limitation (individual glow plugs can be compared for current consumption and control behavior)
  • Short-circuit and reverse voltage protection
  • Surge voltage protection (additional glow plug monitoring via autonomous circuit)
  • Characteristic-controlled testing procedure as in electronic control devices
  • Detects loose contacts by means of processor, then repeats the test
  • Special micro-controller software incorporated into the tester.

Technical Data

  • Power input 8,5–15 Volt Max. current 80 Ampere
  • Test voltage 0–7,5 Volt; After 3 seconds, the voltage goes back to 4.7 volts
  • Test pieces sheathed steel glow plugs and ceramic glow plugs, 3.3 - 15 volts
  • Diemensions 122 x 65 x 40 mm (L x W x D)
  • Weight 250 g
  • Error message:
    → Over-voltage and under-voltage
    → Short-circuit
    → Output (blue test cable) to +12 volt supply
    → Output (blue test cable) to minus

Troubleshooting

If the test does not run as planned it may be for one of the following reasons. Here is how to remedy the situation:

Problem Possible Cause Remedy
The dial continues to be illuminated red; Test procedure does not start “Stop“ is still illuminated yellow Wait until "Start" is illuminated yellow
The dial is not illuminated
  • Plus- und Minus-Anschluss verwechselt
  • Poor contact at connections
  • Ensure good and secure contact
  • Connect the tester correctly. Plus = Red / Minus = Black
No function The input voltage is too low Charge or replace vehicle battery
The dial is fl ashing red
  • Short-circuit measurement or the blue test cable has had ground or plus contact
  • Undervoltage  8.5 V
  • Overvoltage  17 V
  • Briefly disconnect the red plus terminal on the tester and then reconnect (Reset)
  • Check connections
  • Check the voltage supply

Download Flyer »ΝΕΟ: Συσκευή Ελέγχου Προθερμαντήρων« (PDF)